Thistle Threads
Door Hinges
$ 75.00
Thistle Threads
Door Hinges
$ 75.00
This is now discontinued
The Door Hinge is approximately 3" long x 1.5" wide and is used to attach doors lids to the casket body. The Double Casket uses four door hinges. Each door hinge comes with eight tinned pins to attach it to the casket. Each hinge is three separate castings and is assembled by hand in England. It is cast from brass and then tinned like the originals. Four door hinges are required for a set of doors.
Note: These are available to purchase if you are building your own casket. If you are purchasing one from Thistle Threads, all hardware is included.
Related products
-
Thistle Threads
Small Escutcheon
$ 35.00
The Small Escutcheon is approximately 1-3/4" wide x 3/4" high and is placed over a Type 1 Lid Lock. The escutcheon comes with three tinned pins to attach it to the casket. This escutcheon is used on the trinket box and can be exchanged with the large escutcheon on the panel of a double casket. It is cast in brass and tinned afterwards. This small escutcheon was removed from the sliding panel on a double casket and reproduced.Visit product page →
Note: These are available to purchase if you are building your own casket. If you are purchasing one from Thistle Threads, all hardware is included. -
Thistle Threads
Small Lid Hinges
Sold out
Visit product page →The Small Lid Hinge is approximately 1.5" long x 5/8" wide and is used to attach small lids to the casket body. The Double Casket uses two small lid hinges. Each small lid hinge comes with ten screws to attach it to the casket. Each hinge is three separate castings and is assembled by hand in England. Two hinges are needed for the top lid. On the mirror frame with doors you can use two hinges per door if seeing the hinges is desired.
Note: These are available to purchase if you are building your own casket. If you are purchasing one from Thistle Threads, all hardware is included. -
Thistle Threads
Drawer Pulls
$ 25.00
Visit product page →The Drawer Pull is approximately 1" long x 1/4" wide and is attached to the drawer fronts of the three small drawers and one long drawer of the Double Casket. (Note that the other small drawers are designed to have thin silk thread pulls, like the originals). Each pull is two separate castings and is assembled by hand in England with the custom cut cotter pin. The pull is shown installed on a historic casket as a replacement. The bottom pull is an original 17th century pull. Both the original and reproduction is made from brass that is then tin plated or left original.
Note: These are available to purchase if you are building your own casket. If you are purchasing one from Thistle Threads, all hardware is included.If you are building a double casket, 4 pulls will be required
-
Thistle Threads
Mirror Holders (Set of Four)
$ 30.00
The mirror holders are made of brass sheet that are hand turned like the originals. These holders are nailed into the side wood next to a mirror and swivel to hold the mirrors in place in their cavity. I am offering them in both tin plated brass (silver colored) and brass (gold colored) to make the scheme you choose for your casket. These are 1.25" long and were modeled right off a set of originals. They are sold in a set of four.Visit product page →
Note: These are available to purchase if you are building your own casket. If you are purchasing one from Thistle Threads, all hardware is included.
